Features
- Full S-band radar coverage
- 400 W Typical PSAT
- 55% Typical Drain Efficiency
- >10 dB Large Signal Gain
- Pulsed and CW Operation
CGHV38375F
2.75 - 3.75, 400W GaN on SiC HPA
Wolfspeed’s CGHV38375F is a packaged, 400 W HPA matched to 50 ohms at both input and output ports. The CGHV38375F operates from 2.75 – 3.75 GHz providing coverage over the entire S-band radar band. This high-power amplifier provides >10 dB of large signal gain and 40% power-added efficiency and is ideally suited as a high-power building block supporting both pulsed and CW radar applications.
Products
CGHV38375F
No filters selected, showing all 1 products
CGHV38375F
Product SKU | Buy Online | Request Sample | Data Sheet | CAD Model | Recommended For New Design? | Technology | Frequency Min | Frequency Max | Peak Output Power | Gain | Efficiency | Operating Voltage | Form | Package Type |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
CGHV38375F | Yes | GaN on SiC | 2.75 GHz | 3.75 GHz | 400 W | >10 dB | 55% | 50 V | Packaged Discrete Transistor | Flange |
Applications
- Civil and Military, Pulsed and CW S-band Radar
Documents, Tools & Support
- Technical & Sales Documents
- Tools & Support
- Compliance
Documents
Document Type | Document Name |
|---|---|
| Design Files | |
| Data Sheets | |
| S-parameters | |
| Product Catalog | |
| Sales Terms |
Knowledge Center
Continue Reading Technical Articles
Wolfspeed RF GaN meets 5G demands on PA design
Wolfspeed GaN on SiC products can replace inefficient silicon parts in 5G cellular transmitter amplifiers, achieving higher linearization, greater power density and improved thermal conductivity.
Continue Reading Technical Articles
Improving Pulse Fidelity in RF Power Amplifiers
A radar system designer’s most coveted objectives are achieving a long range, adequate resolution to distinguish objects in close proximity to each other, and the ability to not only determine target velocities but target types in order to help differentiate friendlies from adversaries.A combination of both approaches is essential, and engineers can design for peak power points of the load-pull simulation while also paying attention to other parts of the circuit for baseband signal fidelity.
Continue Reading Technical Articles